3.4
Power Cord Installation
1.
Choose the appropriate conduit in accordance with all applicable state,
local and national electrical codes and standards.
2.
Clamp copper terminal to connect copper wire. The clamp point is
covered by heat shrink tube for protecting.
a.
Model
NC8000 80A
Table 3-5 Copper terminal, heat shrink tube and copper wire
© NovaCHARGE 2022 - All Rights Reserved
Figure 3-7 Conduit
Refer to the following wire specification. Use conductor type
other than RHH, RHW and RHW-2 with outer covering.
Terminal
L1, L2
G
Table 3-4 Wire Specification
Conductor
Rating
2 AWG
90C copper wire
8 AWG
Rev 11/2022
13