Table of Contents
Advertisement
2.
Installation
2.1
Before Installation
2.1.1
Safety check
CAUTION: Disconnect the power supply before installing or
repairing the charger. Failure to disconnect may result in
physical injury or damage to the power supply system and
the charging unit.
The NC8000 Series EV Charger - 32A charger must be installed only by a licensed
electrician in accordance with local and national electrical codes and standards.
Before installing the charger, make sure you have read all the instructions in this
manual and fully understand its contents.
Appropriate protection is required when connecting to a main switchboard. Please
refer to section 2.2, Tools and Parts Required for Installation.
2.1.2 Grounding Instructions
Hardwired Connected Product: Grounding Instructions for a hardwired
connected product: This product must be connected to a grounded,
metal, permanent wiring system; or, an equipment-grounding conductor
must be run with the circuit conductors and connected to the
equipment
4
NC8000 Installation Manual-32A
Rev 11/2022
Advertisement
Table of Contents
