Advertisement
HTV8BLEEMVP*1B HTV8BLEEMVP*2B HVT8BLEEMVP*3B HTVDBLMVP*1B HTVDBLMVP*2B HTVDBLMVP*3B
HANGER BRACKET & TRAP INSTALLATION
1) Remove the hanger bracket fastened to back of the
cooler by removing one (1) screw.
2) Mount the hanger bracket as shown in Fig. 2 & Fig 3.
NOTE: Hanger Bracket MUST be supported securely.
Add fixture support carrier if wall will not provide
adequate support. Anchor hanger securely to wall
using all six (6) 1/4 in. dia. mounting holes.
IMPORTANT:
7 in. (178mm) dimension from wall to centerline
of trap must be maintained for proper fit.
INSTALLATION OF COOLER
3) Hang the cooler on the hanger bracket. Be certain the
hanger bracket is engaged properly in the slots on the
cooler back as shown in Figure 3.
4) Remove the two (2) screws holding the bottom cover
at the bottom of cooler. (Shown in Fig. 16) Remove the
bottom cover by pulling straight down and set aside.
5) Connect water inlet line--See Note 4 of General Inst.
6) Install trap. Remove the slip nut and gasket from the
trap and install them on the cooler waste line making
sure that the end of the waste line fits into the trap.
Assemble the slip nut and gasket to the trap and tighten
securely.
IMPORTANT: If it is necessary to cut the wasteline, loosen
the clamp (Item 62) at the drain fitting (Item 41)
and remove. Check for leaks after re-assembly.
8) Plug in electrical power and re-install bottom cover. Unit
must have electrical power to have water flow.
START UP
Also See General Instructions
9) Stream height is factory set at 35 PSI. If supply pressure
varies greatly from this, adjust screw located under
dispenser bottom (Item 39 or 50). See Fig. 3. CW adjustment
will raise stream and CCW adjustment will lower stream.
For best adjustment, stream should be 1-1/2" above
bubbler hood. (See Fig. 4)
NOTE: If continuous flow occurs at the end of the
compressor cycle, turn cold control (Item 16)
counterclockwise 1/4 turn.
CAUTION: PLASTIC COMPONENTS
Any service of this unit that requires use of a torch,
care should be taken not to melt any of the plastic
components. To keep flame away from plastic, the
use of a shield may be required.
CLEANING:
Warm, soapy water or mild household cleaning products
can be used to clean the exterior panels of the HTV
series coolers. Use of harsh chemicals or petroleum
based cleaners WILL VOID THE WARRANTY.
IMPORTANT:
When installing cooler, do not solder 3/8" copper inlet tube
while inserted into union fitting as damage to o-ring and
plastic will result.
HANGER BRACKET (Item 10)
Fig. 3
CORRECT STREAM
PAGE 3
COOLER BACK
HEIGHT
Fig. 4
98413C (Rev. D - 11/08)
Advertisement
