Advertisement
Keypad Tabletop Kit
Installation Guide
Wireless Keypad Wires
White (neutral)
Black (load)
Green (ground)
Tip: To ensure the connected wires will fit into
the base, trim the wires on the keypad to 2 - 3
inches in length before connecting them to the
tabletop base wires.
5
Install the keypad into the keypad tabletop base.
a
Ensure the keypad is
installed in the correct
orientation, with LEDs
on the top of each
button.
b
Ensure the wire
connections with wire
nuts are pushed toward the back of the base
cavity to ensure they do not interfere with
the back of the keypad.
6
Place the keypad tabletop
faceplate in place, ensuring
that the faceplate sits flush
against the screw posts
inside the base.
7
While holding the
faceplate in place, replace
and tighten the screws
to secure the keypad and
faceplate to the keypad
tabletop base.
Wires Inside Keypad
Tabletop Base
Either power cable lead
The other power cable lead
None, but cap with wire nut
8
Plug the installed tabletop
keypad into a power outlet
in a convenient location,
such as near a night stand
or a table near the room
entrance.
9
Configure the device using
Composer Pro.
Regulatory Information
Industry Canada Statement
This Class B digital apparatus complies with Canada ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-
003 du Canada.
ETL Statement
ETL Control Number: 3129831
For use with Control4 Wireless Keypads. When used
with a Control4 Wireless Keypad, this is a double
insulated product.
This product has been tested by ETL and was found to comply with
the Standard for Safety for Information Technology Equipment:
UL/ANSI Standard 60950 (First Edition)
CSA Standard C22.2 No. 60950-1-03 Information Technology
Equipment
Recycling
For information about Control4's recycling program, go to
www.control4.com/recycling.
Warranty
Limited 2-year Warranty. Refer to http://www.control4.com/warranty.
About this Document
Part Number: 200-00065 Rev B, 3/28/2011
Advertisement
