Environmental Requirements - Nortel 4524GT Installation Manual

ESD cable example
To install the ESD discharge cable, perform the following procedure.
Step
1
2
3

Environmental requirements

Table 3 "Nortel Ethernet Routing Switch 4500 Series environmental
requirements" (page 19)
individual switches in this series. Ensure that the area where you install the
switch and where it will operate meets these requirements.
Table 3
Nortel Ethernet Routing Switch 4500 Series environmental requirements
Environmental
requirement
Ambient Temperature
Operating Temperature
Storage Temperature
Operating Humidity
Operating Relative
Humidity
Copyright © 2007, Nortel Networks
.
Action
Connect the ground lug on the ESD discharge cable to a safe and
suitable earth ground.
Briefly connect all RJ-45 cable connectors to the female RJ-45
connector of the ESD discharge cable, and then connect each RJ-45
cable connector to the switch.
Leave cables connected to the networking equipment. After you
connect cables to networking equipment, the cables do not build
up charge.
provides the environmental requirements for the
Nortel Ethernet Routing Switch 4500 Series
All models
0 C to 50 C, continuous operation
0 C to 50 C
-40 C to 85 C
0 to 95 percent non-condensing
10 to 90 percent non-condensing
Nortel Ethernet Routing Switch 4500 Series
Installation Guide
NN47205-300 (322811-B) 03.01 Standard
5.1 19 November 2007
Environmental requirements 19
—End—