Table of Contents
Advertisement
Removing and cleaning the mini motorised pet tool brushbar
IMPORTANT: If the brushbar in the mini motorised pet tool has been obstructed, the brushbar motor
protection sensor may activate and the brushbar will stop. Switch off the machine, remove the tool from
the hose and clear any obstruction. Wait 1 minute before refitting the tool, switch the machine on and
press the brushbar ON/OFF button.
NOTE: For best performance remove and clean the brushbar every 1-2 months (depending on the
level of use) to reduce the hair and dirt build up.
Using a coin, turn the brushbar lock
anticlockwise to release the brushbar.
Check the inlet for any blockages and use
a blunt object to remove the blockage.
Cleaning and maintenance
Pull the brushbar out from the
brushbar housing.
Refit the brushbar and turn the brushbar lock clockwise to lock.
To remove any threads or hair, slide
the blade of a pair of scissors into the
groove on the brushbar and cut along
the groove. Clear any dirt/debris inside
the housing of the floorhead.
15
Advertisement
Table of Contents
