Table of Contents
Advertisement
Utility Requirements and Connections
1. General
Plumbing
2. Drain
3. Electrical
4. Detergent
5. Sanitizer
6. Rinse Aid
7. Installation
Considerations
Main Section Front View
Chemical Pump
GT-18 Glasswasher with
front panel removed
2
GT-18 Series
a. 1/2" OD (or larger) copper to 3/8" FMPT adapter provided
b. Minimum water pressure is 25 PSI
c. Maximum water pressure is 100 PSI. Install water pressure regulator if line pres-
sure is over 100 PSI. Water valve on unit has built-in strainer and flow control to
provide consistent volume between 25 and 100 PSI
d. Install separate water shut-off valve
e. Unit has built-in air gap - vacuum breaker is not required
f.
Maximum temperature is 150ºF (66ºC)
g. Minimum temperature is 120ºF (49ºC)
h. Consumption is 2-1/2 gallons per cycle
a. 1-1/2" tailpiece
b. Use open type floor drain for maximum drainage
a. 120V, single phase, 60Hz, 6-foot grounded cord included
b. Dedicated 15 amp circuit recommended
c. Power requirements - 3.5 amps
a. Extra heavy duty, non-foaming, commercial liquid dishwashing detergent is required -
.30% concentration
b. Consult local chemical supplier to match detergent with local water conditions
a. Liquid chlorine bleach (sodium hypochlorite - 5.25% solution) adjusted to 50 ppm
a. Liquid Rinse Aid adjusted for proper sheeting
a. 1" clearance required to remove top
b. Front side service is essential
c. Detergent, Sanitizer, and Rinse Aid containers are stored externally - six-foot
lengths of tubing are provided. Storage for three one-gallon containers is required
within five feet
Digital
Temperature
Gauge
Start Switch
Prime Switch
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
Electronic
Control Timer
Advertisement
Table of Contents
