Please call the factory between 8:00AM and 5:00PM EST, Monday through Friday. Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780 800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com ndex...
This manual describes the operational features of the GT-18, GT-18+1, GT-18+1L, GT-18+1R, GT-18+2, GT-18+2-IC and GT-18+3 model glasswashers. Please review this information before attempting instal- lation and operation. Long term, trouble-free operation will follow if good housekeeping and maintenance procedures are followed. Thank you for selecting Glastender, Inc. products.
Digital Temperature Gauge Start Switch Chemical Pump Prime Switch Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780 800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com equiremenTS and GT-18 Glasswasher with front panel removed onnecTionS Electronic Control Timer...
Chemical containers should be stored in a manner and/or location that pre- vents them from spilling or splashing. Chemical containers must be secured. Please consult your chemical vendor to ensure proper storage or call the Glastender factory to purchase a clip- on chemical rail, part number 01000710.
The GT-18 glasswasher has a two-minute cycle which consists of the following steps: 1. The drain will close, hot water fills the tank, and detergent dispenses. 2. At 15 seconds, the water recirculating pump starts. 3. At 20 seconds, hot water and detergent stop. NOTE: The detergent is adjustable so this timing may vary.
: Glasswashers are NOT water conditioners. Consult local water conditioning experts to mporTanT noTe determine your specific water condition. Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780 800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com bouT...
The GT-18 glasswasher has chemical pumps that automatically dispense chemicals into the machine. The deter- gent and sanitizer chemicals are supplied by a chemical vendor. Since the type of chemicals and the condition of water varies by region, the chemical pumps are not pre-set at the factory. The chemical pumps must be adjusted at start-up to achieve the proper titration levels or the machine may not produce good wash results.
7. Changing detergents may require readjustment of the Detergent Pump to maintain .30% detergent concentration. A greater volume of low strength detergent is required to maintain the proper level. 8. Only Glastender, Inc. replacement parts should be used. Components from other suppliers may result in machine malfunctions.
Regular maintenance of your Glastender glasswasher will extend its useful life and lower the service costs. The top section of a GT-18 glasswasher is removable to ease regular maintenance. Also, the following parts are removable for daily cleaning: 1. Spray Box 2.
H. Glasses slimy or soapy at end of cycle Recirculating water pressure low Detergent, sanitizer, and/or rinse aid not feeding properly K. Poor washing results Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780 800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com rouble hooTinG auSe No power (Power light “off.”)
Page 16
Expect more more flexibility more features Glastender has the most complete line of bar equipment and the ability to manufacture custom units, giving you virtually unlimited design flexibility. Each piece of equipment is engineered with features that enhance your efficiency, ease your maintenance, and prolong the life of your investment.