Kawai CA901 Owner's Manual page 106

Appendix
3. Mounting the main body (A) onto
the stand
Lift f f the main body (A) and carefully place it so
that the top surface of the left f f and right side
panels (B and C) are visible when viewed from
above.
Move the main body (A) forward so that the
screw holes on the bottom of the main body are
aligned with the holes of the metal ttings on the
left f f and right side panels (B and C). If the screw
holes are not visible, loosen the screws that were
tightened in 2-(4) and readjust them.
CAUTION
When lift f f ing the main body (A) onto the
stand, be careful not to catch/trap hands
and ngers.
106
4. Fastening the main body (A) to the
stand
Loosely fasten the main body (A) to the stand
using four screws (with washer)
Loosely tighten the screws
main body (A) into position so that the four screws
can be inserted straight. Then, adjust the main
body (A) so that the overhang of the main body (A)
is even on the left f f and right when viewed from the
front.
Tighten the loosely fastened screws
the spring washer is compressed.
CAUTION
Tighten all screws securely to ensure that
the main body (A) is rmly attached to the
stand. It is extremely dangerous if the
main body (A) falls from the stand.
.
, and move the
until