Sony DSC-WX150 Service Manual page 11

Installation
1. Align the Lever with the cutout as shown in the figure, and then install the Straight Tube to the Cam Tube B.
Note: Be sure to set the Straight Tube at the correct insertion position.
2. Turn the Straight Tube in the arrow direction to the maximum.
Straight Tube
Lever
Cam Tube B
Cutout
3. Install the Straight Tube Block aligning the thinnest groove with the white part as shown in the figure, and then turn
the Cam Tube B in the arrow direction to the maximum.
Straight Tube Block
Thinnest Groove
White Part
3 Group Assy
4. Install the 2 Group Frame at a position where the Shaft of 3 Group Assy is visible through the cutout of the 2 Group Frame.
Top side view
2 Group Frame
Shaft of 3 Group Assy
DSC-WX150_L2
Straight Tube
Cam Tube B
2 Group Frame
5. Install the 1 Frame Assy so the Lever positions match.
Note: Confirm that the Barrier closes when the 1 Frame Assy is pushed.
1 Frame Assy
Lever
Lever
6. Set the 3 Group Assy in the groove in the orientation where the Flexible Board comes to the nearly opposite side of the cabinet number
on the Cam Tube A.
Note: Be sure to set the 3 Group Assy at the correct insertion position.
7. Push the 3 Group Assy until the three claws lock.
Flexible Board
3 Group Assy
Cam Tube A
Cabinet Number
8. Install the Rotary Cam Tube to the Rotary Tube aligning the semicircular cutout with the Gear edge.
9. Install the Stationary Tube Assy at the position shown in the figure as a guideline.
Note: Be sure to install the Rotary Cam Tube with the semicircular cutout and the Gear edge set in the "OK" state shown in the figure.
10. Install the Main Body so that the Flexible Board position matches the hole to pass the Flexible Board.
OK
Semicircular
Rotary Cam Tube
Cutout
NG
Rotary Tube
Gear Edge
1-9
Claws
Claws
Main Body
Stationary Tube Assy