EAW UXA4401 Quick Start Manual

Carton Contents
Connection Sockets
Network Configurable
Control GPIO
Optional
Dante AoIP
Installation Notes
• High or low impedance speaker connection options can be
selected independently for each output channel via the amplifier
configuration web interface.
• Analogue input sensitivity can be adjusted independently for each
channel via the amplifier configuration web interface.
• S/PDIF digital audio I/O routing can be configured via the amplifier
configuration web interface.
Wireless Network Control Connection
A mobile, laptop or desktop device with WiFi functionality and a web
browser is required.
Follow the steps below.
1. Connect the UXA4401 amplifier to mains power using the
supplied mains cable and wait for the front panel WiFi indicator to
illuminate green.
2. Use a mobile, laptop or desktop device to search for available
WiFi networks. Connect to, 'EAW (product serial number)' using the
password, 'password' . The amplifier serial number can be found on its
rear panel.
3. Open a mobile, laptop or desktop device web browser and enter
the following IP address: 192.168.4.1. The amplifier configuration
web interface page will open in the browser app to enable amplifier
configuration as required.
It is strongly recommended that the UXA4401 amplifier WiFi
password is changed following initial wireless connection.
|
One Main Street Whitinsville, MA 01588
EAW products are continually improved. All specifications are therefore subject to change without notice. ©2021 Eastern Acoustics Works
UXA4401 Quickstart Guide
• Amplifier unit
• Mains power cable
• Input connector x 2
• GPIO socket connector
Configurable
S/PDIF Audio I/O
|
Tel 800 992 5013 / 508 234 6158
• Output connector x 1 or 2
• Adhesive rubber feet x 4
• Document pack
Audio Inputs
Balanced: Euroblock - Unbalanced: RCA Phono.
Configurable
Speaker Output
• GPIO (General Purpose Input/Output) options can be configured via
the amplifier configuration web interface.
• Ensure that rack or other confined installation does not restrict the
airflow required for safe and reliable operation of the equipment. It is
important to ensure that the 40°C maximum operating temperature
for the equipment is not exceeded.
Wired Network Control Connection
A laptop or desktop device with Ethernet functionality, a web
browser and a network scanning app is required.
Follow the steps below.
1. Connect the UXA4401 amplifier Network Control socket to a free
socket on a network router or network switch using an Ethernet
cable.
2. Connect the UXA4401 amplifier to mains power using the supplied
mains cable and wait for the front panel Network indicator to
illuminate green to indicate that the amplifier has been assigned an
IP address.
3. Use a network scanner app to identify the IP address assigned by
the network router to the UXA4401 amplifier.
4. Open a laptop or desktop device web browser and enter the IP
address identified in the Step 3 above. The amplifier configuration
web interface page will open to enable amplifier configuration as
required.
|
www.eaw.com