Verifying The Setup - ALIARO AL-1032 Manual

Connect the RTI and the AL-1032 Board to any DAQ devices or stimuli as defined by their
manufacturer.

Verifying The Setup

The diagram below provides an overview of all product components required and optional for
performing verification. Please note, some components are only optional based on the SLSC
boards being used and the requirements of your system.
Figure 6: Verification System Overview
To verify that all software and product components have been correctly installed, perform the
following actions:
- Power on the SLSC Chassis and observe the front of the AL-1032 Board. The
AL-1032 Board has 2 LEDs which are described in the LED Indicator section of
this document. Verify that both LEDs power solid green when the chassis is
powered on. This verifies that the AL-1032 Board has been installed in the
chassis successfully.
- Using VeriStand – Once the custom device has been installed, add the SLSC
chassis to the system definition file under the Custom Devices section. Add the
AL-1032 Board into this chassis configuration. Deploy the configuration to a
target and use the parameters for the AL-1032 Board created by the VeriStand
custom device.
ALIARO reserve the right to vary from the description given in this data sheet and shall not be liable for any errors.
www.aliaro.com