Advertisement
USE
Operating instructions
(manual version, IR3010)
Lighting the stove
1) Open the gas cylinder tap.
2) With the adjustment dial
in the
position, press
down fully for about 10
seconds.
3) Hold the dial down and at
the same time press the
piezoelectric starter
2-3 times until the pilot
flame lights. When the
pilot flame is lit, continue
holding the dial down for a further 20 seconds to allow
the thermocouple to heat up, then release.
4) If the flame shuts off after the dial has been released,
repeat the procedure described above.
5) To select the required power, press the dial down and
turn as follows:
-
(low flame) low power,
-
(medium flame) medium power,
-
(high flame) high power.
Turning the stove off
Important! To turn the stove off, close the gas cylin-
der tap. The appliance is turned off completely only when the
gas cylinder tap is closed. When the dial is released after the
start-up period, it should rise up to the original height.
If this is not the case, turn the gas off and contact customer
services. Under no circumstances use the stove with the dial
forced downwards.
Operating instructions
(version with thermostat, IR3020)
Lighting the stove
1) Press the enabling button
10 seconds.
2) Hold the enabling button down and at the same time
press the piezoelectric starter button
ton) two or three times to light the flame.
With the flame lit, keep holding the enabling button
down for a further 15 seconds, then release.
Adjustment dial
Selection
indicator
Piezoelectric
starter button
and hold it down for about
(ignition but-
3) If the flame goes out af-
ter the button has been
released, repeat the pro-
cedure described above.
4) Turn the thermostat dial
to the high position 6
(see figure D).
5) When the room has
reached a comfortable
temperature, turn the
thermostat slowly to the
low position until you
hear a click or the two external burners go out.
-
The stove will switch automatically between max and
min power to keep the room at the required temperatu-
re.
Turning the stove off
-
To turn the appliance off, turn the thermostat to the "
position, then close the gas cylinder tap.
Important! The appliance is turned off completely
only when the gas cylinder tap is closed. When the enabling
button is released after the start-up period, it should rise up
to the original height. If this is not the case, turn the gas off
and contact customer services. Under no circumstances use
the stove with the button forced downwards.
MAINTENANCE
With the appliance off and cold only, dust with a soft damp
cloth. Do not use solvents or abrasive cleaning products.
If the appliance is not used for a long period, cover and store
in a dry dust free place. For technical problems or maintenan-
ce, contact your local authorised customer services.
Maintenance must be performed every 2 to 3 years.
If in doubt, contact your local customer services.
5
Use
en
Enabling
Piezoelectric
button
starter button
Thermostat
"
l
Advertisement
