Do you have a question about the KL1 and is the answer not in the manual?
Questions and answers
Davor Maskalenko
March 20, 2025
I got KL1 tablet counter without anything on screen, but when I plug in sounds is active. Do I need replace screen? Thank you.
1 comments:
Mr. Anderson
May 14, 2025
If the Kirby Lester KL1 tablet counter powers on with sound but has no display, it may indicate a screen issue. A screen replacement might be needed. However, further troubleshooting should be done first to rule out other causes like a loose connection or power issue to the display.
Page 1
KL1 Operating Manual RETAIN THESE INSTRUCTIONS FOR REFERENCE www.capsahealthcare.com Kirby Lester, Automation by Capsa Healthcare • 8170 Dove Parkway • Canal Winchester, OH 43110 USA info@capsahealthcare.com • 800.437.6633 • All Rights Reserved • U.S. Patent Numbers 5,317,645 & 5,768,327 5DIM-380301-OM-Rev B...
Page 2
8 7) Kirby Lester Service pg. 8 Kirby Lester, Automation by Capsa Healthcare • 8170 Dove Parkway • Canal Winchester, OH 43110 USA info@capsahealthcare.com • 800.437.6633 • All Rights Reserved • U.S. Patent Numbers 5,317,645 & 5,768,327 5DIM-380301-OM-Rev B...
Page 3
Slide the counting tray completely into the KL1 (Fig. 1). Connect the power cord to the back of the KL1 and plug the other end into a standard power outlet. Turn the power switch to “On” (Fig. 1). See power requirement information on p. 7.
Page 4
Stop, remove the tablets from the tray, reinsert the tray and repeat the count. Partial Pill Message The KL1 will beep if it detects a partial tablet/fragment that is less than 25% (approx.) of a whole tablet. The orange Partial Pill indicator will flash (Fig. 7). ...
Page 5
The 4-digit red display on the KL1 will remember the quantity at which it stopped. Empty the tablets into another receptacle, reinsert the tray, and continue to pour the remainder of the tablets.
Page 6
In general, prolonged alcohol exposure causes faster wear-and- tear on plastic. Kirby Lester, Automation by Capsa Healthcare • 8170 Dove Parkway • Canal Winchester, OH 43110 USA info@capsahealthcare.com • 800.437.6633 • All Rights Reserved • U.S. Patent Numbers 5,317,645 & 5,768,327...
Page 7
Green/Yellow: Earth Green: Ground If you change the plug of the KL1, note the above. If colored markings in the plug don’t correspond, proceed as follows: The neutral wire must be connected to the terminal marked N The live wire must be connected to the terminal marked L...
Page 8
Read this Operating Manual carefully. If additional help is required, contact Customer Service at 800.243.2465 or techsupport@capsahealthcare.com. Kirby Lester, Automation by Capsa Healthcare • 8170 Dove Parkway • Canal Winchester, OH 43110 USA info@capsahealthcare.com • 800.437.6633 • All Rights Reserved • U.S. Patent Numbers 5,317,645 & 5,768,327...
Need help?
Do you have a question about the KL1 and is the answer not in the manual?
Questions and answers
I got KL1 tablet counter without anything on screen, but when I plug in sounds is active. Do I need replace screen? Thank you.
If the Kirby Lester KL1 tablet counter powers on with sound but has no display, it may indicate a screen issue. A screen replacement might be needed. However, further troubleshooting should be done first to rule out other causes like a loose connection or power issue to the display.
This answer is automatically generated
What is error E-3