Daikin EKRUMC Installation Manual page 6

Refer to figure 3.
1 10-class address card
2 Shielded cable (field supply)
3 Shield of the cable
NOTE It is recommended to connect the shielded cable to
the address card before installing the remote user
interface.
Before starting up the unit for the first time, make sure
that it has been properly installed. It is therefore
necessary to read the installation manual supplied with
the unit and the recommendations listed in "Checks
before initial start-up" carefully.
H
OW TO INSTALL THE REMOTE USER INTERFACE
Turn the power off before installing the remote user
interface.
Setting the buzzer on or off
It is possible to silence the buzzer by setting dipswitch 3 on the
remote user interface to OFF. The figure shows the default setting.
ON
1 2 3 4
The setting of the dipswitch has to be performed
NOTE
before fixing the remote user interface to the wall.
Installation manual
3
ON buzzer on
OFF buzzer off
?
EKRUMC
Remote user interface
4PW16029-1