ECO-WORTHY 5A User Manual page 7

OPERATING INSTRUCTIONS:
AUTOMATIC MONITORING- Your new battery charger is completely automatic and
can be left on whenever input power is made available to the charger. The charger
output depends on the condition of the battery it is charging. When the battery is fully
charged, the "Good" will indicate and battery indicator will show "100%" , then the
charger will switch itself To a storage charge mode and will automatically monitor
and maintain the battery at full charge
CABLE CONNECTIONS- Your new battery charger is equipped with two output
Leads, a red positive Lead, and a black negative clip Lead and a permanent mount
eyelet Lead with a 2 pin SAE connector. Always connect or disconnect the output
Leads before plugging into AC power For all battery types: Connect the red positive
(+ lead to the positive terminal of the battery. Connect the black negative(-)lead to
the negative terminal of the battery
NOTE: If the charger is left connected to a lead acid battery for long periods of time,
check water levels periodically as directed by the battery manufacturer to ensure
electrolyte is maintained at proper level
ATTENTION: THE BATTERY CHARGER HAS A SPARK FREE AND REVERSE
POLARITY PROTECTION . AS A GOOD PRACTICE, NEVER ALLOW THE TWO
CLIPS TOUCH EACH OTHER
The battery charger will not produce voltage (turn on) until it recognizes at least two
volts from the battery. The battery charger clips must be clipped to a battery in the
correct polarity to initiate output voltage and begin charging when in Lead Acid(Pb)
charge mode When in Lead Acid(Pb) charge mode if the charger is hooked up in
reverse polarity, the red "Reverse Polarity" light will flash indicating that the connec-
tion has been made in reverse of the polarity of the battery and a charge has not
been initiated. The clips must be re-connected in the proper polarity to start the
charger, Red to positive(+to +) and Black to Negative( -to-)
NOTE: DO NOT TURN YOUR BATTERY CHARGER ON AND OFF REPEATED-
LY (Plug and Unplug) WITHIN A SHORT PERIOD. IF THIS HAPPENS,
UNPLUG BATTERY CHARGER FROM AC POWER, WAIT FOR ONE MINUTE
AND THEN CONNECT THE CHARGER AGAIN TO RESTART CHARGING
CYCLE
- 6 -