Advertisement
Available languages
Available languages
TROUBLE MESSAGE LIGHTS CHECKLIST
NO LCD signal
LCD Signal is ON,No charging current
BAT LOW signal is ON
BAD BAT signal is ON
The charger is charging but the 20-100%
signal does not come on
A.Disconnect the charger from the AC
outlet Check connections to battery
and ensure they are good
B.Check to ensure that there is power
at the AC outlet by plugging in a table
lamp or power meter
A.Battery is not connected
B. The battery may be damaged or
below 2 volts, charge process will not
begin. In this case the"Bad Battery"
Light will be on
Battery voltage is under 9V
The battery is worn out or is possibly
defective Suggest replacing battery
with a battery.
A.The battery is worn out or is possibly
defective
Suggest
replacing battery with battery
B.The battery may have an excessive
current draw caused by a potential
short circuit. Disconnect battery from
charger. Suggest testing and/or replac-
ing battery
C.The charged battery is larger than
the charger marked capacity (shown in
manual) Please recharge with larger
capacity charger
- 12 -
testing
and/or
Advertisement
