Related Manuals for D&R ELECTRONICS Ford F-150 K9 Kennel
Summary of Contents for D&R ELECTRONICS Ford F-150 K9 Kennel
- Page 1 Ford F-150 K9 Kennel P/N 934-0729A INSTALLATION MANUAL CONTENTS Unpacking Installation Warranty Return Policy...
- Page 2 UNPACKING Quantity Description Before beginning any installation, unpack the 1/4-20 x 3/4" Button Head Screws equipment received. After unpacking, 1/4-20 Lock Washer examine ALL components received for any damage that may have occurred while in transit. 1/4-20 Flat Washer If any damage has occurred, file a claim IMME- 1/4-20 x 1"...
-
Page 3: Vehicle Preparation
VEHICLE PREPARATION Remove the 2 rear seats and set aside. Some Plastic floor panels may require remov- al as well. The removed seat bolts will be used to fasten the sub-frame to the floor. Remove Passenger and Driver Side Rear door panels and set aside. The Door Locks may require disassembly in order to tuck away door lock rods. - Page 4 Step 2 Floor Panel to Sub-frame Place Floor panel on sub-frame. Do not secure. Step 3 Back Panel and Side Panel to Floor Panel & Sub- frame Place Back panel and both side panels on sub- frame and secure with Sub-frame and Floor Panel using 1/4-20 –3/4”...
- Page 5 Step 4 Install Roof Holding Brackets Remove the hook from the roof and install the roof holding brackets both sides. Step 4 Roof Panel to Back Panel, Side Panels and Roof Holding Brackets. Place the roof panel on the back panel and secure to the back panel, side panel and roof brackets.
- Page 6 Step 6 Sliding Door To Front Panel The front sliding door comes assembled with slides and latch. Line up the holes in the front panel with the studs on the slides and secure using 1/4-20 Nylock nuts. Ensure proper slide movement and latch functioning. Step 7 Front Panel to Floor Panel, Sub-frame &...
- Page 7 Step 8 Front Panel Enforce Chan to Front Panel Install the front panel enforce chan to the front panel using #10-32 Screws and wash- ers. Step 9 DS & PS Side Covers Place PS Side Cover and secure to Front Panel and Side Panel using 1/4-20 x 3/4” Button head screw, 1/4”...
- Page 8 Step 10 Side Steps Insert Side Steps both sides and secure with Floor Panel using #10-32 x 1/2” Flat Head Screw. Secure with Front Panel and Side panels using 1/4-20 x 3/4” Screw, lock Washers and Flat Washers. Step 11 Door Cover Panel to PS Door Ensure that the window switch is connected, speaker removed and locking rod folded away before installing the door cover.
- Page 9 Step 12 Window Guard Place the supplied window guard against the window frame. Adjust and mark holes to be drilled for 3/16 rivets and rivet the window guard in place. Adjust the mounting brackets, if required. Note: Divider Assembly The divider assembly comes pre-installed on the back panel for ease of installation. For using the divider, remove the 1/4-20 screws on divider joining bracket on the driv- er side, expand the divider and screw the small door of the divider to the Front Panel Enforce Chan on the passenger side.
- Page 10 Step 14 Rubber Matting Place Rubber Matting in Vehicle. CAUTION HEAVY LIFTING REQUIRED. The Installation procedure is now complete. Please contact D&R Electronics if you require fur- ther assistance or would like a soft copy of this publication.