Page 1
2020 U lity Console with Sliding Armrest 901-0164B (Images are Based off 901-0165B) Installa on Manual Content Page Assembly Overview Installa on Instruc ons 901-0165B Document Rev 1 December, 2019...
Page 3
Top View Figure 1.3 Bo om View Figure 1.4 901-0165B Document Rev 1 December, 2019...
Page 4
Driver’s Side View Figure 1.5 Passenger’s Side View Figure 1.6 901-0165B Document Rev 1 December, 2019...
Page 5
Installa on Instruc ons: Step 1 Remove the Factory Floor Plate by removing the 2 bolts located under the dash, 2 inside the cutouts on top of the plate and bolts on the back side of the plate. Re- tain the hardware for new consoles. Before A er Step 2...
Page 6
Step 3 Disconnect the three highlighted wiring harnesses located at the back of the low- er dash sec on. Step 4 Remove the factory accessories from the lower dash sec on. Retain the hardware. CAUTION: DO NOT hammer or force the plas c covers. They have a pin on each side, that must be pressed using a small flat-head screwdriver when installing.
Page 7
Step 5 A ach the lower dash sec on back in. Run the three harnesses through the hole that used to house the parking brake. Bolt the sec on back in place using the 2 bolts removed in step 1. Step 6 Re-install both USB port and cigare e lighter on the top of new console, as shown below in the le image.
Page 8
Step 8 Remove the indicated 6 factory nuts, using a 10 mm socket. Retain the hardware for future steps. Step 9 Disconnect the wiring harnesses located as shown below. 901-0165B Document Rev 1 December, 2019...
Page 9
Step 10 Mount the Console Mid Moun ng Base using the nuts removed in the previous step. Ensure to apply pressure on the Console Mid Moun ng Base towards the front of the vehicle while ghtening down. Step 11 Place the new console on top of the Console Mid Moun ng Base. Push the con- sole forward ght to the dash and secure with the hardware removed in step 7.
Page 10
WARRANTY D & R Electronics warrants its new products to be free from defects in material and workmanship, under normal use and service, for a period of one year on parts replacement, and one year on la- bor. This warranty applies only to original purchasers acquiring the product directly from D&R Electron- ics, or its authorized dealers.