Advertisement
Portofino Installation Guide
After cutting the side of the underframe to size, apply
5
silicone to the mitred faces of the front and side
sections and assemble the underframe using the
connectors provided. Fully tighten the grub screws.
Replace the assembled underframe in position on the
floor or tray and mark its position.
Insert the 10 mm spacer into the underframe channel
7
and use it to align one of the wall profiles. Push the
profile down as far as it will go and, using a spirit level
to ensure that it is perfectly vertical, mark the screw
hole positions on the wall and then remove the profile.
Repeat this process with the second wall profile.
Drill 6 mm holes where marked and insert wall plugs.
The Majestic Shower Company Limited
17 Flitch Industrial Estate, Chelmsford Road,
Dunmow, CM6 1XJ
Run a substantial bead of silicone along the centre of
6
the underframe to seal it against the floor or tray and
apply a small amount of silicone in the corners where
the underframe will sit against the wall.
Replace the underframe in position where you have
marked the floor or tray and tape it in place whilst the
silicone sets.
In Line
panel
Reposition the wall profiles and insert the top and
8
bottom screws to hold them in place.
Remove the 10mm spacer and insert rubber strips into
the underframe channels where the Return panel and
the In Line panel will sit.
Telephone (0) 1279 443644
info@majesticshowers.com
www.majesticshowers.com
Page 6
Return
Panel
Advertisement
