Advertisement
Portofino Installation Guide
12.5mm
The other length of vertical seal is to be cut in 3
21
sections to fit to the Door above below and between the
hinges.
For maximum resistance to leakage, the seal
sections should be cut as shown above to allow them
to fill the gaps in the hinge through which water might
otherwise escape.
Cut the horizontal seal to the width of the door and fit
23
it to the bottom edge of the door with the deflector
blade facing inwards as shown.
Trim the ends of the deflector blade back so that it
clears the vertical seals, both of which should run
down to the top of the underframe.
The Majestic Shower Company Limited
17 Flitch Industrial Estate, Chelmsford Road,
Dunmow, CM6 1XJ
Slit here
Horizontal seal
notched at each
end to clear
vertical seal
Vertical seal extends
down to underframe
PANEL SIDE
Slit
VIEW FROM
INSIDE OF
ENCLOSURE
(OUTWARD
OPENING
DOOR)
GLASS NOT
SHOWN
Slit
Open the door and slide the 3 sections of seal on to
22
the edge of the Door, pushing the notched ends
inside the hinge as shown.
OUTWARD
INWARD
OPENING
OPENING
DOOR
DOOR
Push the underframe insert into the underframe
24
channel under the door noting the difference in
orientation for outward and inward opening doors.
The vertical blade of the insert should be notched at
each end as shown to allow any water to drain back
from the underframe to the inside of the shower
enclosure.
Telephone (0)1279 443644
info@majesticshowers.com
www.majesticshowers.com
Page 10
DOOR SIDE
Notch
Notch
5-6mm
Notch
Advertisement
