Table of Contents
Advertisement
Installation
H
1. Shut-off the water serving the pipe where the
valve is to be installed. Drain the water from the
pipe, by turning on a faucet, or by other method
as required.
2. Depending on the adapter fitting used, mea-
sure the length of pipe that must be cut, and
mark the cut lines on the pipe, as shown below.
3. Cut the water pipe through the mark using a
pipe cutting tool, then remove the cut section of
pipe, as shown below.
4. Sand both ends of cut pipe, removing any
burrs or rough edges. Use care handling the cut
edges, which may be sharp! Wipe off the cut
section of pipe with a clean cloth.
08
Advertisement
Table of Contents
Need help?
Do you have a question about the YS5002-UC and is the answer not in the manual?
Questions and answers