Cellularline Flag - Wireless Stereo Bluetooth Headset Manual

Description

1. MFB touch control
2. Earbud LEDs
3. Charging Case charge indicator LED
4. MicroUSB charging socket
5. MicroUSB charging cable

PRELIMINARY OPERATIONS

Recharge Charging Case: insert the charging cable (5) into a USB port of a mains charger or PC and connect the connector to the MicroUSB charging socket (4), the flashing orange LED (3) indicates that the Charging Case is charging.

On completion of charging, the LED (3) will stay on, now disconnect the Charging Case from the power supply.

NOTE: the flashing white LED indicates that the charge of the Charging Case has run out.

Charging the Earbuds: put the devices in their housings and they will automatically be charged. The lighting up of the orange LEDs (2) indicates that the devices are charging, when the charging is complete, the LEDs (2) will switch off.

Connection to the phone when using for the first time: charge the earbuds by inserting them into their housings.

After recharging CELLULAR FLAG follow the instructions below to establish the connection with the phone.

Remove the devices from the Charging Case and wait for the automatic connection between them. Once the connection has been established, the LED (2) of one of the two earbuds will flash orange/white alternately, indicating that the pairing mode is active.

Activate the phone's Bluetooth to search for devices and select CELLULARLINE FLAG when it is detected.

USING THE DEVICE IN STEREO

Switching on: remove the devices from the Charging Case or press the MFB touch control for 2 seconds.

Switching off: insert the earbuds into their housings or press the MFB touch control for 2 seconds.

Answering/ending a call: Press the MFB touch control (1) of one of the two earbuds twice.

Play/Pause: press the MFB touch control (1) of one of the two earbuds twice.

FF: press the MFB touch control (2) of the right earbud for 2 seconds to advance to the next song.

Rew: press the MFB touch control (1) of the left earbud for 2 seconds to go back to the previous song.

Speaker volume adjustment: use the phone's volume buttons to adjust the volume.

Low battery indicator: the acoustic signal indicates that the battery charge has run out.

RESET

If there are any anomalies in the operation of the device, it is possible to carry out a reset to restore the initial operation.

• delete all previous pairings from the phone's Bluetooth menu and restart it.
• press the MFB button 5 times quickly; you will hear a tone and both LEDs will start flashing red/white simultaneously.
• press once on both earbuds.
• put the earbuds back in the case.

Proceed with pairing again: remove the earbuds from the case; one of them will start flashing red/white alternately. Enable the Bluetooth on your phone and manually select CELLULARLINE FLAG when detected.

EARBUDS TECHNICAL SPECIFICATIONS

Bluetooth: v 5

Profiles supported: Headset – Handsfree – A2DP - AVRCP

Range: 10mt

Bluetooth Frequency range: 20-2KHz

Battery Voltage: 3.7V

Battery Capacity: 30mAh X 2

Charging Case battery capacity: 500mAh

MicroUSB port Voltage (V): 5V

MicroUSB port current (A): 400mA

ERP: 3mW

Stand-by Time: 100 hours

Talk Time: 3.5 hours

Play Time: 4 hours

Earbuds charging: about 1 hour

Recharge Charging Case: about 2 hours

Weight: 41g