Table of Contents
Advertisement
You can change the auxiliary functions, speed and temperature settings without stopping the programme flow while
the programme is running. To do this, the change you are going to make must be something that will be carried out
after the programme step that is running. If the change is not suitable, relevant lights will flash 3 times.
C
INFORMATION
• If the machine does not proceed to the spinning step, the Rinse Hold function might
be active or the automatic unbalanced load detection system might be activated due
to the unbalanced distribution of the laundry in the machine.
4.3.14 Loading door lock
There is a locking system on the loading door of the machine that prevents opening of the loading door in cases
when the water level is unsuitable.
Loading door light will start flashing when the machine is switched to Pause mode. The machine checks the level of
the water inside. If the level is suitable, the loading door light will turn off and the loading door can be opened within
1-2 minutes.
If the level is unsuitable, the loading door light will remain on and the loading door cannot be opened. If
you are obliged to open the loading door while the Loading Door light is on, you must cancel the current
programme. See "Cancelling the programme"
Opening the loading door in case of power failure:
A
WARNING!
• Before opening the loading door, make sure that there is no water in the machine to avoid flooding. Water
may be hot and could cause scalding.
• Turn off and unplug the appliance.
• Open the pump filter lid.
• Remove the loading door emergency handle behind the filter cover with a tool.
• Open the loading door by pulling the loading door emergency handle downwards.
• Try to pull the handle downwards again if the loading door is not opened.
• Bring the loading door emergency handle to its original position after opening the loading door.
Washing Machine / User's Manual
23 EN
Advertisement
Table of Contents
