8/10
COIL D36 | Product overview
Bosch Rexroth AG, RE 18324-42/2023-02-17
3.4 Intended use
The product is an electronic component, designed for use in hydraulic systems.
It is used for the composition of electrohydraulic valves, in combination with the
mechanical section.
The coil must be used as follows:
▶ in compliance with the use and ambient conditions as per the data sheet
▶ in compliance with the performance limits
▶ in its original and undamaged condition
▶ no repairs can be carried out by the customer. Maintenance is to be carried
out exclusively using authorised replacement parts. Replace defective products
immediately with a new device or with genuine original replacement parts.
▶ Use of the DIN 43650 connector is mandatory.
3.5 Technical data
In reference to the technical data of the coils illustrated in the following instruction
manual, end users should view the document available at this link:
https://www.boschrexroth.com/it/it/media-details/04972e0d-ec02-4864-
9625-320da5f16d96
3.6 DIN 43560 connector
Figure 2 - DIN 43560 connector, male connector (viewed from coil).
▶ PIN1 = Power supply (+)
▶ PIN2 = Power supply (-)
▶ PIN3 = Not used
▶ PIN4 = Ground (GND)