The Arrow QG (Arrow VI) appears to the user or a server application as a single endpoint device. It can be queried, updated, and configured either through a serial connection or an over-the air (OTA) LTE IP connection.
8-pin Power Consumption <5 Watts Arrow QG (Arrow VI) provides support for specialized hardware features through extended AT commands. The features supported include the following: The major functionality of the GPS system is to compute the correlation results between the incoming signal and the selected PRN code based on certain Carrier Doppler Frequency, code phase, carrier phase, and the particular satellite the system is tracking or acquiring.
MDM9207-1 chipset provides internal software and hardware Watchdog. Motion Detect This function will work with firmware power down options to keep the Arrow QG (Arrow VI) in a very low power down state until motion is detected. Upon wakening, a report can then be generated.
Need help?
Do you have a question about the Arrow QG and is the answer not in the manual?
Questions and answers