Advertisement
Step 3:
Through the bottom side holes of the
Radiator Guard, slide-in the Washer
M6 (2) and Screw M6 x 20 (3), and
secure the threads on the mounting
holes, near the bottom of the Radiator.
Copyright By SRC
Design and Specification are subjected to change
Step 4:
Ensure the Guard is not fouling with
any outside surfaces of the Radiator
and on the outside with the Twin
frames, and tighten the screws to
the torque, as shown in the BOM
table.
Radiator Guard is shown in "Final
Mounted condition"
Page 4
Advertisement
