Valcom VIP-904 Quick Start Manual

QUAD HANDSFREE VOIP ADAPTER
INTRODUCTION
The VIP-904 Quad Handsfree VOIP Adapter
connects Valcom MultiPath talkback paging
system zones to Valcom Enhanced Network
Audio Port devices (VIP-80x series) for
distribution over an IP network. Up to four
MultiPath zones may be connected to each
VIP-904, with each connected zone requiring one
port on a Valcom VIP-801, VIP-802 or VIP-804.
The MultiPath zone audio will be distributed by
the Enhanced Network Audio Port over the IP
network to other IP endpoint devices. Contact
closures (call button presses) will be passed over
the IP network from the zone endpoint to initiate a
call into the MultiPath.
SPECIFICATIONS
Access Methods
MultiPath zone audio output with optional
Contact Closure (call in switch) connection
Features
Four 4-pin screw terminal MultiPath
connections
Four RJ-45 Enhanced Network Audio Port
device connections
Dimensions/Weight
7.19" H x 3.75" W x1.31" D
(18.3 cm H x 9.5 cm W x34.3 cm D)
Weight: 1.0 lbs. (0.45 kg)
Nominal Specifications
Input Impededance:
Input Level:
Output Impedance:
Output Level:
Environment
Temperature:
Humidity: 0 to 85% non-precipitating
VIP-904
Packing List
INSTALLATION
Mounting
The VIP-904 is designed for wall mounting.
Using the wood screws provided, secure the VIP-
904 to the wall through the mounting holes in the
outer flange of the VIP-904.
Power Connections
The VIP-904 does not require a separate power
source.
Signal Connections
The VIP-904 has 4 screw terminal block
connectors for 4 separate paging zones. Four
RJ-45 jacks provide connections to a VIP-801,
VIP-802 or VIP-804 Enhanced Network Audio
Port. Labeled Port 1, Port 2, Port 3 and Port 4.
600 Ohms
each of the screw terminal blocks corresponds to
-10dBm
the Port directly across from it.
600 Ohms
-10dBm nominal
Paging System Connections: Connect the
audio Tip and Ring from a MultiPath page
controller zone to the screw terminals labeled
0 to 40° C
Audio of one screw terminal block. If a Contact
Closure (call in switch) connection is required,
connect the contact closure from the same
MultiPath zone to the screw terminals labeled
Contact. (See Figure 1).
1
Qty Item
1 VIP-904
1 VSP Document
4 Wood Screws
ISSUE 1
947709