Advanced Settings - SENSY WIRELESS-T24-HA User Manual

2.7.

Advanced Settings

You should not normally need to change these settings.
Items you can change:
Waker Duration
Do Sleep Wake
Auto Off Delay
Keep Awake Interval
Pair Wait Duration
Item Duration
MA-WIRELESS-T24-HA_EN.docx
When the handheld is turned on it may attempt to wake the paired transmitter
modules. This setting allows you to adjust the time it will wait to wake the remote
modules in milliseconds. The default is 12000.
You can select whether the handheld wakes the remote transmitter modules on power
up and sends them to sleep on power down.
Select No to disable this function. The default is Yes.
Here you can specify the delay in minutes after which the handheld will automatically
turn off after no button is pressed.
Enter zero to disable this function. The default is 5 minutes.
While the handheld is retrieving data from the transmitter module it periodically sends
out a Keep Awake packet. This will stop the transmitter module from going to sleep
while the handheld is in use. The default is 5 seconds.
Here you can set the duration that the handheld will wait to achieve successful pairing
when it is turned on in Pairing mode. The default is 5 seconds.
Used when in Result Mode and the Next key has been enabled to allow viewing of
discrete inputs. Enter a time in seconds that the individual item value will be displayed
for before the display is automatically switched back to showing the result.
Page 16 on 18 Rev: 08/02/2017