Table of Contents
Advertisement
Use the manual Beichen Automation BCNET-FX-S Ethernet communication processor
At this time, the IP address of the communication test is 192.168.1.135, which
is the IP address of the module as the Station mode
Parameter configuration and diagnostics through BCDevice
At this point through the BCDEVICE module parameters can be configured and
diagnosed, the above figure describes the"Device operation diagnosis" bound
Below, "WiFi interface status"> "Station (module connection hot spot)",
you can see that the running status of the Station is"Cheng."
Power connection hot spot", and the connection hot spot signal strength is"-
4 DBM (signal strength)", the current IP address is
"192.168.1.135";
PLC programming software connection
Advertisement
Table of Contents
