Switch Setting And Speaker Connection - Toa DA-X1000S Instruction Manual

7.1 SWITCH SETTING AND SPEAKER CONNECTION

[1 input 1 output ]
(Factory Setting)
8. CONNECTION OF DETACHABLE WIRING PLUG
Attentions
• Be sure to use the shield wire.
• Please pay attention to the exposed part of the wire. Please avoid tin plating.
When tying the wire, if the solder is damaged, it may increase the contact resistance, resulting in an abnormally
increased temperature at the contact site.
Use the AWG 16-28 type for the wire type.
• Exposed part of the wire
• Connection steps for the
Step 1. Unscrew the screw in the terminal and insert
the cable.
Step 2. Tighten the screw in the terminal.
Make sure the wire is not extended
and elongated.
7
ACTIVE connector
The volume
potentiometer
Power switch
connector.
disconnected
The volume potentiometer
adjusts the lowest level.
OFF
tighten
terminal screw
1
ACTIVE-B
ACTIVE-A
one-shaped screwdriver
unscrew
detachable wiring plug
5
H (+)
C (-)
E (GND)
10Ω