Advertisement
This device is exclusively intended for use in private domains in accordance with this manual and may not be used for commercial purposes. Any other form of use constitutes improper use and can result in material damage and even personal injury.
Please pay attention that also children and handicapped people must comply with these instructions!
indicates the dangers that will result in death or severe injury.
indicates the dangers that in rare cases will result in minor or moderate injury.
Risk of accident, if used when on the road and in potentially hazardous situations.
permanent hearing damage and hearing loss due to high volume.
The functioning of electronic implants (pacemakers, etc.) are influenced, if radio is at close range.
Danger of fire, explosion, burns if the operating temperature is substantially exceded, if the electronics housing is opened and in case of battery short-circuit, when touching the leaking battery.
With this headset you can
Before first use the headset must be fully charged at least for 4 hours.
For this purpose, use the included USB cable. Connect a USB power source with min. 100mA to the charging socket (E) on the handset. The control LED (C) lights up red during charging and turns off when fully charged (2-3 hours).
To switch on, press the key (D) for at least 2 seconds. The control LED (C) flashes blue after the switching-on if no Bluetooth device is connected (compare the paragraph PAIRING). If a known, active Bluetooth device is nearby, the handset connects automatically, and the control LED will light up continuously in blue. To switch off, press button (D) for min. 3 seconds. The control LED flashes red. With no device connected, the receiver switches off automatically after 3 minutes.
To pair with a Bluetooth device, refer to the instructions of the Bluetooth device. If you switch on the handset, the flashing blue control LED indicates the coupling mode. Now start the search function on your Bluetooth device. Shortly, the handset will be displayed as "BTHP260". Confirm pairing on your Bluetooth device. Handset and device are now connected and the control LED on the receiver lights up continuously in blue. Once a device is paired, it will be normally recognized and automatically connected after each switching-on/off.
By pressing and holding buttons (A) and (B).
For a phone call, use your phone normally. The transfer takes place automatically on the coupled handset. A phone call can be accepted and concluded by pressing button (D) on the handset.
Decouple the handset in the Bluetooth menu of your Bluetooth device.
According to the used Bluetooth device from the handset you can control other functions of your device.
Use the supplied audio cable and connect the music source to the audio jack (F) on the handset.
LOW BATTERY LEVEL LED (C) flashes blue
Hereby Vivanco GmbH declares that article BTHP 260 complies with the essential requirements and the other relevant regulations of the guideline 2014/53/EU. Declaration of conformity can be www.vivanco.de
This device shall not be disposed with household waste. Please hand it over to any collection point for electric devices in your community or district.
Packing material shall be recycled. Please do not dispose with household waste and act according to local disposal regulations.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Vivanco BTHP 260 - 2in1 Bluetooth Headphones Manual
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the BTHP 260 that isn't answered in the manual? Leave your question here.