Kohler REVE K-24766T-S Installation Instructions Manual page 21

Installation For In-wall Tank Without Frame
A. Installation of In-wall Tank
A.
1. Remove in-wall tank from packing box. Remove front cover
board or top cover board inside water tank first as shown.
Then remove paper board, support block and plug above
bracket assembly.
1.
2. Make sure of h according to dimensions of bowl and then
locate the installation hole of fixing bracket. Mark on the
wall for appropriate position for fixing bracket, and drill four
holes with diameter of 12mm and depth of 80mm with
churn drilling as shown in illustration, and fill in the holes
with expanding bolt cap and tighten the screw to set the
fixing bracket.
Note: Ensure the fixing bracket to remain level.
2.
12mm 80mm
O
3. Put the tank onto the fixing bracket as shown in the right
figure and adjust the tank to level .
Note: it is a must to keep the tank level.
3.
1402749-T01-A
h
-15-
Cover,Top
Cover,Top
Plug
h
Cover,Front
Supporting Board
Paper Board
Cover,Front
Expanding
Bolt Cap
Z-connecting Plate
Z
Screw
Washer
Level
Tank