Table of Contents
Advertisement
Available languages
Available languages
Fire dampers BTK...
ASSEMBLY PREPARATION
Fig. 1 Assembly of end switch BA-S (Accessories)
Pos. 1
Insert holder in the inner ring of the fire damper into T-nut
Pos. 2
Push holder down to lock in the T-nut
Pos. 3/4 Clip BA-S end switch to the holder. Then test the functioning of the switch.
Pos. 1
Holder
Fig. 2 Replace the fusible link
Pos. 1
Push molten solder to the side against the lever and remove
Pos. 2
Insert replacement fusible link (Accessories, Ref. no. 84974) in the fusible link holder and snap into place
Pos. 1
Fig. 2 Attach the fusible link
Pos. 3
In order to attach the fusible link, bend the locking springs in the inner ring of the fire damper outwards
Pos. 4
Push the two semi-circular damper blades together so that the fusible link can be attached to the locking catch.
WARRANTY CLAIMS – EXCLUSION OF LIABILITY
If the previous instructions are not observed, our warran-
ty and treatment on a goodwill basis shall not apply. The
same applies for liability claims against the manufacturer.
Pos. 2
Pos. 2
Fusible link
Fusible link holder
Pos. 3
Pos. 3
Catch spring
REGULATIONS – GUIDELINES
If the product is installed correctly and used to its inten-
ded purpose, it conforms to all applicable regulations and
CE guidelines at its date of manufacture.
0749 CPR BC1-606-0464-15650.69-2517
3
Fig.1
Pos. 4
Fig.2
Pos. 4
0749
Advertisement
Table of Contents
