Westfalia One Touch 92 29 05 Original Instructions Manual page 11

Using the Can Opener
1. Place the can opener on top of the can with
its rim positioned in the groove at the
bottom of the can opener (see fig. B).
Notes: The cutter will not operate unless it is
positioned properly on the rim of the can. To
open cans with tab, turn them upside-down,
so that the can opener can work on the lid
without tab.
2. With the can on a flat surface, press the start
button (1) for about one second and release
it once the can opener starts to cut the can
(see fig. C). After cutting, the can opener will
stop automatically (see fig. D).
Note: The maximum can size that can be fully
cut in one cycle is 98 mm diameter. If you
need to completely remove the lid of a bigger
can, press the start button again and the can
opener will resume cutting and stop
automatically after cutting.
3. When cutting is completed, lift the can
opener off the can. A magnet (9) on the can
opener will pick up the lid for your
convenience (see fig. E).
Note: There is a functional sharp edge on the
round cutter. It should be treated with care.
Press and Hold Button
11
Can Rim in Groove
Ø52 – 153 mm
B
C
D
E