First Use; Control Panel; Operation - VALBERG BI CS 249 F W742C Instructions For Use Manual

B B
appliance complies with E.E.C. directives.

First use

Cleaning the interior
• Before using the appliance for the first time, wash the inside of the appliance and all internal
accessories with lukewarm water and a little neutral soap to remove the odour typical of a
new product. Then dry them completely.
WARNING
Do not use detergents or abrasive powders, as these will
damage the finish.

Control panel

18
Buttons
• B1 – Press this button to adjust the refrigeration compartment cycle setting from 1, 2, 3, 4 to 5.
• B2 – Press this button to select a mode between Smart, Super and user settings.
Indicators
• L1 – indicates the refrigerator compartment setting
• L2 – lights up after selection of the Smart mode.
• L3 – lights up after selection of the Super mode.

Operation

Temperature setting
• Press the Mode (B2) button to select the user settings.
• Press the Adjust (B1) button to adjust the refrigerator settings. A lower setting is equal to
a lower temperature. The freezer temperature is automatically set to around -18 °C.
Smart mode
• Select the Mode (B2) button to select the Smart mode.
• The appliance works automatically depending on the ambient temperature around it.
Super mode
• Select the Mode (B2) button to select the Super mode.
• The appliance works to lower the temperature of the freezer compartment as much as
possible. After 54 hours, the set initial temperature is restored.
Switching off the appliance.
• Push the Adjust (B1) button and hold it down for 5 seconds, the appliance stops. Press again
for 5 seconds to switch on the appliance.
When using the appliance Utilisation de l'appareil
9 9 EN FR