Advertisement
Assembly Instructions
ASSEMBLY RA TING
Tools Required For Assembly:
The Assembly Rating is a 5-point system that
Allen Wrench
shows the degree of effort needed in
(Included)
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
o1FFICULT
O O O @@
EASY
�
2 PERSONS RECOMMENDED
Page 1 of 6
Advertisement
Table of Contents
Related Manuals for Furniture of America CM7930CK
Summary of Contents for Furniture of America CM7930CK
- Page 1 Assembly Instructions ASSEMBLY RA TING Tools Required For Assembly: The Assembly Rating is a 5-point system that Allen Wrench shows the degree of effort needed in (Included) assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
- Page 2 ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST.CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used in Position each part correctly and insert Use cardboard or carpet area when an assembly, please make sure the screws or bolts into their respective...
- Page 3 Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. Hardware List Parts List r:t�?JJ "I #Ax 18pcs Headboard Bolt 1/4" X 15 mm 0))= �:l3f:�:tj #Bx 8pcs Footboard Bolt 1/4"...
- Page 4 1. Insert an extension leg (#8) into each end of the headboard (#1). 2. Once inserted, align a connecting plate (#E) to the pre-drilled holes and insert 2 bolts (#A). Secure using the Allen wrench (#F). Repeat on the other leg. 3.
- Page 5 Prepare 2 slats (#5) and 2 slats (#6) by aligning a support leg (#7) to the bottom then apply a flat washer (#D) onto the bolt (#C) and insert that bolt assembly into the top of the slat. Secure using the Allen wrench (#F). 1.
- Page 6 1. Place the slats (#5) in the two outer slots and the slats (#6) in the two center slots. 2. Prepare 8 bolt assemblies by inserting a flat washer (#D) onto the bolts (#A). Then insert the bolt assemblies into the side rails from below and secure using the Allen wrench (#F).
Need help?
Do you have a question about the CM7930CK and is the answer not in the manual?
Questions and answers