Advertisement
Setting up your Hub 5
To Connect through Wi-Fi:
using the WLAN SSID (Network Name)
and password (WLAN Security)
printed on the back of the router
Once connected, open a browser
and make sure you can access
different web pages.
Once browsing, Internet LED light
at the front of the Hub would be
blinking Green
Tip:
If still unable to connect, or if the Internet LED light is solid red,
perform a factory reset by holding the Reset button on the back
of your Hub for 10 seconds, then wait three minutes before turning
back on.
Connect Your Wi-Fi Units for Whole Home Wi-Fi
Step 4: Connect Your Whole Home Wi-Fi
The Xplore Whole Home Wi-Fi network enables you to have superior
coverage in every room in bigger homes. It does that by deploying one or
more Whole Home Wi-Fi Units in different locations to extend your Hub's
signal. If you do not have this option you can skip this step.
1.
If you already have Xplore Whole Home
Wi-Fi Units that are in use, you will need
to perform a factory reset first using
the button on the back (hold
for 10 seconds, wait 3 minutes
for it to power fully). Repeat for
all units.
2.
Plug the first new or existing
Whole Home Wi-Fi Unit into a
power outlet near the location
where you would like it installed.
Wait 3 minutes for it to start up.
LED Light at the front of the Whole
Home Wi-Fi Units would be solid Red
while unit is booting up
(Continued)
Connect
XPLORE HUB
|
E AS Y S E T UP GU ID E
Hub 5
Reset
Back of Whole Home Wi-Fi Unit
Front view of
Whole Home
Wi-Fi Unit
3
Advertisement
