NETGEAR DS104 Install Manual
  1. Manuals
  2. Brands
  3. NETGEAR Manuals
  4. Switch
  5. DS104
  6. Install manual

NETGEAR DS104 Install Manual

Dual speed hub
Hide thumbs Also See for DS104:

Advertisement

Table of Contents

See also: Installation Manual

Advertisement

Table of Contents
loading

Related Manuals for NETGEAR DS104

Summary of Contents for NETGEAR DS104

  • Page 2: Start Here

    — Additional LEDs providing network traffic status for the hub — Two LED bar graphs (on the Model DS104, Model DS106, and Model DS108 only) providing online status of network utilization and alerting you to potential network overload —...

  • Page 3: Package Contents

    Rubber footpads Wall mount hardware Installation guide, Warranty & Owner Registration Card, Support Information Card Caution: Use the appropriate power cord as required by your national electrical codes and ordinances. Model DS104/DS106/DS108/DS116 Dual Speed Hub Installation Guide Power adapter 9498FA...

  • Page 4: Typical Applications

    Refer to the following illustration when connecting your DS100 Series hub. The illustration shows a Model DS116 hub connecting users to a printer, servers, and a router. You can substitute a Model DS104, Model DS106, or Model DS108 hub, depending on the number of connections required.

  • Page 5: Product Illustration

    Product Illustration Front Panel of the Model DS104 Hub Front Panel of the Model DS106 Hub DS106 DUAL SPEED HUB >40 Utilization% Front Panel of the Model DS108 Hub 100 Mbps Collision LED 100 Mbps Utilization LEDs DUAL SPEED HUB...
  • Page 6 Model DS104, Model DS106, and Model DS108 LEDs Label Color Activity Power Green Collision 10 Mbps Amber 100 Mbps Amber Utilization% 10 Mbps Green Blinking 100 Mbps Green Blinking 10M or Green 100M Link/ Receive (built into each vista RJ-45...

  • Page 7: Rear Panel

    Vista RJ-45 Network Ports with Built-in LEDs The front panel of the Model DS104 hub provides four vista RJ-45 network ports (six on the Model DS106 hub, eight on the Model DS108 hub, 16 on the Model DS116 hub). These standard RJ-45 connectors accept two-pair or four- pair Category 5 unshielded twisted pair (UTP) copper wiring (only two pairs are used).

  • Page 8: Installation Procedures

    To install the hub on a flat surface: 1. Set the hub on a table or shelf so that it has at least 2 inches (5 cm) of space on all sides. 2. Connect the power cord(s) first to the power entry receptacle on the hub rear panel and then to the wall.

  • Page 9: Connect A Pc To The Hub

    Uplink (MDI) or Normal (MDI-X) position for port 4 on the Model DS104 hub, port 6 on the Model DS106 hub, port 8 on the Model DS108 hub, and port 16 on the Model DS116 hub. All other ports are wired Normal for direct connection to PCs.

  • Page 10: Connect Hubs At 10/100 Mbps

    Connect Hubs at 10/100 Mbps 10 or 100 Mbps Transmission with the Hub Two Model DS104 hubs, two Model DS106 hubs, two Model DS108 hubs, two Model DS116 hubs, or a combination of DS100 Series hubs can be daisy- chained together at 100 Mbps to support a growing number of PCs. For larger networks, use a 10/100 Mbps switch such as the NETGEAR Model FS104 switch, as shown in the illustration below.

  • Page 11: Verify The Installation

    • Utilization LEDs on the front panel are blinking when data is being received by any port in the hub, and the Link/Receive LED on the connected port is blinking when data is being received by that port. If there are any problems, refer to the Troubleshooting table.

  • Page 12: Technical Specifications

    UL listed Power adapter cUL listed TUV licensed T-Mark Warranty Limited Lifetime Power adapter 3 YEARS Model DS104/DS106/DS108/DS116 Dual Speed Hub Installation Guide Model DS108 Model DS106 Model DS104 9.3 in. 9.3 in. 6.2 in. (235 mm) (235 mm) (158 mm) 1.1 in.

  • Page 13: Replacement Power Adapter

    If you are replacing a power supply, please confirm the voltage required by looking on the back of the hub. If you own an early version of the DS104, DS106, or DS108 that is 5 V, please order the DS116 power supply.
  • Page 14 EN 55 022 Statement This is to certify that the Model DS104 Dual Speed Hub, Model DS106 Dual Speed Hub, Model DS108 Dual Speed Hub, and Model DS116 Dual Speed Hub are shielded against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a.
  • Page 15 NETGEAR, Inc. 4500 Great America Parkway Santa Clara, CA 95054 Phone: 1-888-NETGEAR E-mail: support@NETGEAR.com http://www.NETGEAR.com *M-DS100NA-3*...

This manual is also suitable for:

Ds108Ds106Ds116

Table of Contents