Camera Placement - Swann CoreCam Pro Quick Start Manual

The camera can be conveniently placed on a table or shelf, or mounted on a flat surface using the
included bracket. Because the camera is completely wire-free, you'll have a lot of flexibility on where you
can install it. Choose a location with strong, reliable Wi-Fi reception to ensure best video streaming and
battery performance. The easiest way to check is to use your smartphone. Connect your smartphone to
your Wi-Fi network at the spot you have chosen and see if you get 2 bars of Wi-Fi signal or more. As a
general rule, the nearer the camera is to your router, the better the wireless connection quality. If you're
finding the wireless signal is too weak or out of range, consider installing a Wi-Fi range extender.
Mounting the bracket
If mounting to a wooden surface, screw
bracket directly to the surface.
If mounting to a masonry surface (brick,
concrete), mark and drill holes, insert wall
plugs, and screw bracket to the surface.
Adjusting the viewing angle
Loosen the adjustment ring slightly by
turning counter-clockwise. Swivel or tilt
the camera as needed then tighten the
adjustment ring to lock the position.
EN
6

CAMERA PLACEMENT

After installation, make sure to
remove the protective plastic film
covering the camera lens.
Attaching the camera to the bracket
Screw the threaded hole at the bottom of the
camera onto the threaded post of the bracket
by turning the locking knob clockwise until the
camera is securely attached.