Procedures; Switches Location And Pin-Out - BRP Sea-Doo RXP Series Shop Manual

Section 06 STEERING AND PROPULSION
Subsection 02 (iBR, REVERSE AND VTS)
NOTE: If iBR gate is not in the neutral position be-
fore the engine start, it will move to the neutral
position on engine start up.
2. Depress the throttle lever slightly, then release
it. Forward movement of the watercraft con-
firms the iBR gate has moved to the forward
position.
3. Depress the iBR lever fully. Rearward move-
ment of the watercraft confirms the iBR gate
has moved to the reverse position.
4. Release the iBR lever completely. Reverse
thrust should cease and the watercraft should
continue to drift rearward on momentum.
5. Apply a small amount of forward thrust to stop
rearward velocity, then tap the iBR lever to re-
turn the iBR gate to neutral.
6. Shut engine off.

PROCEDURES

SWITCHES LOCATION AND
PIN-OUT
219101005-033-010
BRLS LOCATION
smr2014-119-008_a
BRLS PINOUT
158
219101005-033-007
STEERING CONNECTOR LOCATION
smr2014-030-012_a
STEERING CONNECTOR
219101005-033-008
IBR ACTUATOR CONNECTOR LOCATION
219101039-016