MAINTENANCE PROCEDURES
This subsection includes instructions
for basic maintenance procedures.
WARNING
Turn off the engine, remove tether
cord cap and follow these mainte-
nance procedures when perform-
ing maintenance. If you do not
follow proper maintenance pro-
cedures you can be injured by hot
parts, moving parts, electricity,
chemicals or other hazards.
WARNING
Should removal of a locking device
be required (e.g. lock tabs, self-
locking fasteners, etc.) when un-
dergoing disassembly/assembly,
always replace with a new one.
Air Intake Silencer
Prefilter
Air Intake Silencer Prefilter
Verification
Ensure that air intake silencer prefilter
is properly installed, clean and in good
condition.
mmo2011-007-011_a
1. Prefilter
To remove prefilter, simply pull it out.
To install prefilter, push it back in place
making sure it is properly secured.
______________
86
Engine Coolant
(Except 550F)
WARNING
Never open coolant tank cap when
engine is hot.
Engine Coolant level
The engine coolant tank is located be-
hind the upper RH side panel. See
CONTROLS, INSTRUMENTS AND
EQUIPMENT
for removal procedure.
The cold level line is just above the re-
taining clamp.
Check coolant level at room temper-
ature with the cap removed. Liquid
should be at cold level line (engine cold)
of coolant tank.
NOTE: When checking coolant level at
low temperature it may be slightly be-
low the cold level line.
To add coolant, remove front coolant
tank fixation and slightly pull the tank
outwards to make room for the cap.
If additional a large amount of coolant
has to be added or if entire system has
to be refilled, refer to an authorized
Ski-Doo dealer, repair shop, or person
of your own choosing.
mmo2009-004-028_b
TYPICAL
1. Coolant tank