TDR S161 Operating Instructions Manual page 23

IX. CARE AND MAINTENANCE
MOTOR BRUSHES
The motor brushes are housed inside of the motor/transaxle assembly. They
should be inspected periodically for wear by your authorized provider.
CONSOLE, CHARGER AND REAR ELECTRONICS
Keep these areas free of moisture.
Allow these areas to dry thoroughly if they have been exposed to moisture before
operating your Travel Scooter again.
NYLON LOCK NUT REPLACEMENT
Any nylon insert lock nut removed during the periodic maintenance, assemble or
disassemble of the Travel Scooter must be replaced with a new nut. Nylon insert
lock nuts should not be reused as it may cause damage to the nylon insert,
resulting in a less secure fit. Replacement nylon insert lock nuts are available at
local hardware stores or through your authorized our provider.
STORING YOUR TRAVEL SCOOTER
If your plan on not using your travel scooter for an extended period of time, it is
best to :
1.Fully charge its batteries prior to storage.
2.Remove the battery pack from the travel scooter.
3.Store your Travel Scooter in a warm, dry environment.
4.Avoid storing your travel scooter where it will be exposed to temperature
extremes. Batteries that are regularly and deeply discharged, infrequently charged
stored in extreme temperatures or stored without a full charge may be
permanently damaged, causing unreliable performance and limited service life. It
is recommend that you charge the Travel Scooter batteries periodically throughout
periods of prolonged storage to ensure proper performance.
WARNNG! Always protect batteries from freezing temperatures
and never charge a frozen battery.
For prolonged storage, you may wish to place several boards under the frame of
your Travel Scooter to raise it off of the ground. This takes the weight off the tires
1
and reduces the possibility of flat spots developing on the areas of the tires
contacting the ground.
41
41
IX. CARE AND MAINTENANCE
DISPOSAL OF YOUIR COOTER
Your Travel Scooter must be disposed of according to applicable local and
national statutory regulations. Contact your local waste disposal agency or your
authorized provider for information on proper disposal of packaging, metal frame
components, plastic components, electronics, and batteries.
42