Table of Contents
Advertisement
VI. COMFORT ADJUSTMENTS
FRONT STORAGE AREA
Your Travel Scooter is equipped with a front storage area that can be removed if
additional leg or foot room is needed. See figure 18. Remove the screws to
separate the small basket from the Travel Scooter.
NOTE: As a precaution, avoid placing wallets, keys, or valuable items in the
storage area.
VII. DISASSEMBLY AND ASSEMBLY
DISASSEMBLY
You can disassemble the Travel Scooter into four pieces:the seat the frame, the
basket, and the battery pack. See figure 19.
No tools are required to disassemble or assemble your Travel Scooter. Always
disassemble or assemble your Travel Scooter on a level, dry surface with
sufficient room for you to work and move around--about five feet (1.5 meters) in all
directions. Remember that some Travel Scooter components are heavy and you
may need assistance when lifting them.
1
Figure 19. Disassembled Travel
36
VII. DISASSEMBLY AND ASSEMBLY
WARNING! Do not lift weight beyond your physical capability.
Ask for assistance when necessary while disassembling or
assembling your Travel Scooter.
1.Remove the seat by lifting it straight up and off of the Travel Scooter. If you
encounter resistance when removing the seat, disengage the seat rotation lever
and swivel the seat back and forth while lifting up on the seat.
2.Remove the battery pack from the Travel Scooter.
Frame Separation
1.Lower the tiller and tighten the taller adjustment knob.
ASSEMBLY
1.Raise the tiller and fully tighten the tiller adjustment knob.
2.Reinstall the battery-pack.
3.Reinstall the seat and rotate is until it is secured into place.
VIII. BASIC TROUBLESHOOTING.
Any electrical mechanical device occasionally requires some trouble-shooting.
However most of the problems that may arise can usually be solved with a bit of
thought and common sense. Many of these problems occur because the batteries
are not fully charged or because the batteries are worn down and can no longer
hold a charge.
DIAGNOSTI BEEP CODES
The diagnostic beep codes for your Travel Scooter are designed to help you
perform basic troubleshooting quickly and easily. A diagnostic beep code will
sound in the event one of the conditions listed below develops.
NOTE: Your Travel Scooter will not run unless the beep code condition is resolved
and the Travel Scooter has been turned off then turned back on.
What if all the systems on my Travel Scooter seem to "dead"?
Make certain that the key is in the " on " position.
Check that the batteries are fully charged .
Push in the main circuit breaker reset button. See III."Your Travel Scooter."
Be sure the power down timer feature has not been activated
.
37
Advertisement
Table of Contents
