Table of Contents
Advertisement
III. YOUR TRAVEL SCOOTER
The main circuit breaker reset button pops out when the breaker trips.
When the breaker trips, the entire electrical system of your Travel Scooter shuts
down.
Allow a minute or two for your Travel Scooter's electronics to "rest".
Push in the reset button to reset the main circuit breaker.
If the main circuit breaker trips frequently, you may need to charge your
batteries more often.you may also need to have your authorized provider perform
a load test on your Travel Scooter's batteries.
If the main circuit breaker trips repeatedly, see your authorized our provider for
Service.
TILLER CONSOLE FUSE
The fuse located under the battery pack protects the tiller console
electronics. See figure 8.
In the event any component of the tiller console is not responding,
. " Basic Troubleshooting" for fuse replacement
check this fuse. See
VIII
instructions.
1
Figure 7. Battery Pack(20AH)
Pack Shown
Figure 8. 3-Amp Tiller
Console Fuse
22
III. YOUR TRAVEL SCOOTER
OFF-BOARD BATTERY CHARGER
The off -board battery charger, when plugged into the charger power cord
receptacle ( located on the battery pack) and a standard electrical outlet, charges
the Travel Scooter's batteries, See figure 9.
Figure 9. Off- Board Battery Charger
SHROUD PANELS
You can change the color of your Travel Scooter by removing the colored plastic
shroud panel pieces and replacing then with one of the other supplied sets.The
panels are held in place by a hook and loop reusable fastener.
To remove the shroud panel pieces:
1.Use your finger to locate the push hole behind each shroud piece.
2.Push through the hole to separate the piece from the Travel Scooter.
See figures 10,11.
Figure 10 Front Fender panel Figure 11.Rear Fender Panel
23
22
Advertisement
Table of Contents
