Comfort Adjustments - TDR S161 Operating Instructions Manual

V.OPERATION
shuts down automatically. If the power down timer feature takes effect, perform the
following steps to resume normal operation.
1.Remove the key from the key switch.
2..Reinsert the key and power up your Travel Scooter.
VI. COMFORT ADJUSTMENTS
TILLER ANGLE ADJUSTMENT
WARNING! Remove the key from the key switch before adjusting
the tiller or the seat. Never attempt to adjust the tiller or the seat
while the Travel Scooter is in motion.
Your Travel Scooter is equipped with an adjustable pivoting tiller.
1.While supporting the tiller, turn the tiller adjustment knob counterclockwise to
loosen the tiller. See Figure 15.
2.Move the tiller to a comfortable position.
3.Turn the tiller adjustment knob clockwise to secure the tiller in position.
Figure 15. Tiller Adjustment Knob.
NOTE: In order to fully lover the tiller, you must first remove the seat and
battery pack. Remove the seat by pulling it straight up and off the Travel
Scooter.
1
SEAT ROTATION ADJUSTMENT
The seat rotation lever, located on the fight side of the seat
Figure 16. Seat
34
VI. COMFORT ADJUSTMENTS
base, secures the seat into several positions.
1.Pull up on the seat rotation lever to disengage the seat.
2.Rotate the seat to the desired position.
3.Release the lever to secure the seat into place
ARMREST WIDIH ADJUSTMENT
The armrest width can be adjusted inward or outward
1.Loosen the armrest adjustment knobs .See figure 16.
2.Use the attached ring to pull and remove pins.
3.Slide the armrests in or out to the desired width.
4.Align the adjustment holes on the seat frame and armrest, then reinsert pins.
5.Tighten the armrest adjustment knobs.
NOTE: Pivot the armrests upward to aid in getting onto and off of your
Travel Scooter.
Seat HEIGHT ADJUSTMENT
The seat can be positioned to different heights See figure17.
Figure 17. Seat Height Adjustment Figure 18. Front Storage Area.
1.Remove the seat and battery pack from your Travel Scooter.
2.Use the attached ring to pull and remove the pin from the lower seat post.
3.Raise or lower the upper seat post to the desired seat height.
4.While holding the upper seat post at that height,align the adjustment holes of the
upper and lower seat post.
5.Fully insert the pin
6.Replace the battery pack and seat.