Page 1
VOKKERO GUARDIAN US User Guide Version 1.0.0 210794A VOKKERO Adeunis NA Adeunis 25 Main Street, 3rd Floor 283 rue Louis Néel - Parc Technologique Pré Roux Tuckahoe, NY 10707 38920 CROLLES - France www.vokkerousa.com www.vokkero.com...
VOKKERO GUARDIAN C2C - User Guide V1.0.0 PREAMBLE • This guide describes the functionality of the system GUARDIAN C2C, options and accessories. It explains how to configure it to allow a conference-type communication between multiple users. • No part of this document may be reproduced or transmitted (in electronic or paper, or photocopying) without the agreement Adeunis. This document may be changed without notice.
VOKKERO GUARDIAN C2C - User Guide V1.0.0 Table des matières PREAMBLE INTRODUCTION SYSTEM INSTALLATION PROCEDURE SYSTEM DESCRIPTION 2.1. Functioning and communication capabilities 2.2. GUARDIAN C2C Terminal 2.2.1. Description of product interface 2.2.2. General characteristics 2.3. GUARDIAN C2C Charger/Configurator 2.3.1. Description of product interface 2.3.2.
Page 5
Up to : ARF8320C DISCLAIMER This document and the use of any information contained therein, is subject to the acceptance of the VOKKERO terms and conditions. They can be downloaded from www.vokkerousa.com. VOKKERO makes no warranties based on the accuracy or completeness of the contents of this document and reserves the right to make changes to specifications and product descriptions at any time without notice.
Page 6
VOKKERO GUARDIAN C2C - User Guide V1.0.0 COMPLIANCE TO FCC US/CAN This device complies with part 15 of the FCC rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: • This device may not cause Harmful interference •...
Page 7
VOKKERO GUARDIAN C2C - User Guide V1.0.0 FOR PORTABLE DEVICE USAGE (<20CM FROM BODY/SAR NEEDED) RADIATION EXPOSURE STATEMENT: The product comply with the FCC and ISED portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual.
Page 8
IMPORTANT: Before using the device, please observe the legal provisions in force in your country. In this 915 MHz FHSS version, GUARDIAN C2C is transmitting in frequency hopping mode. You can set the terminal with 7 different tables of channels.
Page 9
Under no circumstances can the manufacturer, or the distributor of an VOKKERO program, be held liable for any damage caused by the use of the aforesaid program. Program names, as well as all copyright relating to programs, are the exclusive property of VOKKERO.
Page 10
VOKKERO GUARDIAN C2C - User Guide V1.0.0 WARNINGS Valid for : GUARDIAN C2C US: ARF8320C Read the instructions in the manual. The safety of this product is only guaranteed when it is used in accordance with its purpose. Maintenance should only be carried out by qualified persons.
(Optional) Charger extension (1 to 4 maximum) All the operating settings of the GUARDIAN C2C system are managed by the configurator which gives access to the Settings menu via a touchscreen. The configurator must be connected to the power unit (otherwise it will not work) and up to 4 extensions can be associated with the configurator.
By default, standard channel tables are Home 1 and Away 1. You can activate access to Home 2, Away 2, Home 3, Away 3 with the System menu. • If 2 sets of GUARDIAN C2C share the same field during a game, configure the systems respectively Home 1 and Away 1 to ensure the best radio functionality.
VOKKERO GUARDIAN C2C - User Guide V1.0.0 2.2. GUARDIAN C2C Terminal 2.2.1. Description of product interface Antenna Headset connector Flexible radio antenna. Connect to a headset (must be compatible with the terminal). Device on and Network «Volume» selector connection. Trigger Button to adjust the vo- lume of the headset loudspeaker.
• Press the On/Off button to turn on the terminal. The LCD screen should turn on and display the VOKKERO® logo. The LED above the On/off button should also light up permanently. Next, the Welcome Screen displays, followed by the product name. By default, the product name «Guardian»...
VOKKERO GUARDIAN C2C - User Guide V1.0.0 3.3. Connecting a headset Several types of headsets from the VOKKERO range can be connected to GUARDIAN C2C. The headset is automatically detected by the terminal when the headset is plugged in. 3.3.1.
VOKKERO GUARDIAN C2C - User Guide V1.0.0 3.4. Terminal operation 3.4.1. Volume Adjust the terminal volume with the Volume trigger button. • Push the trigger upwards to increase the volume • Push the trigger downwards to decrease the volume The volume can be adjusted in a range from 0 to 10 When you increase or decrease the volume, you will hear a beep.
VOKKERO GUARDIAN C2C - User Guide V1.0.0 3.4.4. Call button to Head Coach Use the Call button to send an alert to the Head Coach; If you are not part of the current group of discussion, you can ALERT the HEAD COACH with a alarm/call button if you need to communicate with him.
VOKKERO GUARDIAN C2C - User Guide V1.0.0 3.4.7. Battery The terminal’s button can be removed and recharged on the charger. Removing the battery Remove the battery from the terminal by pressing the locking mechanism at the top of the terminal and then slide the battery downwards.
C2C. The configurator has a USB port for updates. The configurator screen is a high-resistance touchscreen. Immediately upon starting up the system, the configurator displays the VOKKERO logo, with the firmware version of the configurator, followed by the Home Screen.
VOKKERO GUARDIAN C2C - User Guide V1.0.0 4.2.1. Set-up a spare terminal for Head Coach In case the numbers you have entered for OFFENSE terminals and DEFENSE terminals to configure is inferior of one unit to number of terminals put on the configurator: •...
VOKKERO GUARDIAN C2C - User Guide V1.0.0 4.3.1. Devices configuration This screen indicates the terminals present on the configurator. The charge status as well as the name of each terminal displays. The terminals display in their order of presence on the configurator, going from the closest (HEAD COACH in position 1) to the furthest away.
Page 23
If you want to be able to talk to the HC permanently or you just want to change your Role (switching from OC to DC and vice & versa) : Before to launch a configuration (« Quick Settings » menu) to pair the C2C terminals in communication on the configurator, you can activate the « Role Change » option following this procedure: •...
Page 24
If you want to disable Vocal synthesis which is announced at the change of communication mode as decided by the Head Coach. Before to launch a configuration (« Quick Settings » menu) to pair the C2C terminals in communication on the configurator, you can desactivate the « Vocal synthesis » following this procedure: •...
Page 25
VOKKERO GUARDIAN C2C - User Guide V1.0.0 F.3 - Voice sensitivity Normal mode is the default mode. This allows clear communication in noisy environments. Whisper mode allows the terminal to recognize whispers and low tones. Important note: Whisper mode only works in a quiet environment (it should not be activated in a noisy environment).
Home 1 and Away 1 to ensure the best radio functionality. • If a set of GUARDIAN C2C share the same field with a Vokkero SQUADRA Pro or VARSITY referee communication system during a game, configure the system Home 2 or Away 2 to ensure the best radio functionality with the referee communication system.
Page 27
VOKKERO GUARDIAN C2C - User Guide V1.0.0 C - Language You can change the system’s display language by means of the “Language” setting. Choose the language you want and validate with on the bottom right-hand side. D - Update software You can update the software versions of the terminals and / or the configurator.
Page 28
VOKKERO GUARDIAN C2C - User Guide V1.0.0 • Updating terminals To update terminals you have to use a USB key. Contact your vendor to obtain the most recent software version. The USB key used must be < or = 4Go.
Page 29
VOKKERO GUARDIAN C2C - User Guide V1.0.0 • Updating the configurator To update the configurator you have to use a USB key. Contact your vendor to obtain the most recent software version. The USB key used must be < or = 4Go.
VOKKERO GUARDIAN C2C - User Guide V1.0.0 4.3.3. Configurator configuration Use this setting to adjust the screen. In this area, you can adjust the screen lighting, calibrate the touchscreen, and lock the configurator. 1 - Adjusting the screen lighting Slide the cursor from left and right to decrease and increase, respectively, screen lighting.
Unplug the configurator Reconnect the configurator When the configurator is switched on, on the first home screen, consisting of the «VOKKERO®» logo: press exaclty on the 2nd «O» of VOKKERO®. Then you can restore the default settings of the configurator Confirm The configurator parameters have been reset.
Page 32
VOKKERO For any requests, contact us at: (844) 865-5376...
Need help?
Do you have a question about the C2C and is the answer not in the manual?
Questions and answers