Erasing The Configuration; Upgrading The Router Software - NETGEAR KWGR614 Reference Manual

To restore your settings from a saved configuration file, enter the full path to the file on your
computer or click the Browse button to browse to the file. When you have located it, click the
Restore button to send the file to the router. The router will then reboot automatically.
Note: You must not interrupt the router while it is rebooting.

Erasing the Configuration

It is sometimes desirable to restore the router to the factory default settings. This can be done by
using the Erase function, which will restore all factory settings. After an erase, the router's
password will be password, the LAN IP address will be www.routerlogin.net, and the router's
DHCP client will be enabled. For other default settings, refer to
Appendix A.
To erase the configuration, click the Erase button.
To restore the factory default configuration settings without knowing the login password or IP
address, you must use the Default Reset button on the rear panel of the router. See
Default Configuration and Password" on page

Upgrading the Router Software

Note: Before upgrading the router software, use the router backup utility to save your
configuration settings. Any router upgrade will revert the router settings back to
the factory defaults. After completing the upgrade, you can restore your settings
from the backup.
Maintenance
54Mbps Wireless Router Model KWGR614 Reference Manual
6-7.
v1.2, September 2006
"Factory Default Settings" in
"Restoring the
4-11