Table of Contents
Advertisement
Select the DNS Configuration tab.
6.
If any DNS server addresses are shown, write down the addresses. If any information appears
in the Host or Domain information box, write it down. Click Disable DNS.
Click OK to save your changes and close the TCP/IP Properties dialog box.
7.
You are returned to the Network window.
Click OK.
8.
Reboot your PC at the prompt. You may also be prompted to insert your Windows CD.
9.
Obtaining ISP Configuration Information for Macintosh Computers
As mentioned above, you may need to collect configuration information from your Macintosh so
that you can use this information when you configure the HR314. Following this procedure is only
necessary when your ISP does not dynamically supply the account information.
To get the information you need to configure the router for Internet access:
From the Apple menu, select Control Panels, then TCP/IP.
1.
The TCP/IP Control Panel opens, which displays a list of configuration settings. If the
"Configure" setting is "Using DHCP Server", your account uses a dynamically-assigned IP
address. In this case, close the Control Panel and skip the rest of this section.
If an IP address and subnet mask are shown, write down the information.
2.
If an IP address appears under Router address, write down the address. This is the ISP's
3.
gateway address.
If any Name Server addresses are shown, write down the addresses. These are your ISP's DNS
4.
addresses.
If any information appears in the Search domains information box, write it down.
5.
Change the "Configure" setting to "Using DHCP Server".
6.
Close the TCP/IP Control Panel.
7.
Restarting the Network
Once you've set up your computers to work with the router, you must reset the network for the
devices to be able to communicate correctly.
Turn off the DSL or cable modem, wait 15 seconds, and then turn it on again
1.
Preparing Your Network
Reference Manual for the Model HR314 802.11a Hi-Speed Wireless Router
3-11
Advertisement
Table of Contents
Troubleshooting
