NETGEAR HR314 Reference Manual page 119

netmask
Network Address
Translation
packet
PPP
PPP over Ethernet
PPTP
PSTN
Point-to-Point
Protocol
RFC
RIP
router
Routing Information
Protocol
SSID
subnet mask
Glossary
Reference Manual for the Model HR314 802.11a Hi-Speed Wireless Router
A number that explains which part of an IP address comprises the network
address and which part is the host address on that network. It can be
expressed in dotted-decimal notation or as a number appended to the IP
address. For example, a 28-bit mask starting from the MSB can be shown as
255.255.255.192 or as /28 appended to the IP address.
A technique by which several hosts share a single IP address for access to the
Internet.
A block of information sent over a network. A packet typically contains a
source and destination network address, some protocol and length
information, a block of data, and a checksum.
See Point-to-Point Protocol.
PPPoE. PPP over Ethernet is a protocol for connecting remote hosts to the
Internet over an always-on connection by simulating a dial-up connection.
Point-to-Point Tunneling Protocol. A method for establishing a virtual private
network (VPN) by embedding Microsoft's network protocol into Internet
packets.
Public Switched Telephone Network.
PPP. A protocol allowing a computer using TCP/IP to connect directly to the
Internet.
Request For Comment. Refers to documents published by the Internet
Engineering Task Force (IETF) proposing standard protocols and procedures
for the Internet. RFCs can be found at www.ietf.org.
See Routing Information Protocol.
A device that forwards data between networks. An IP router forwards data
based on IP source and destination addresses.
A protocol in which routers periodically exchange information with one
another so that they can determine minimum distance paths between sources
and destinations.
Service Set Identification. A thirty-two character (maximum) alphanumeric
key identifying the wireless local area network. For the wireless devices in a
network to communicate with each other, all devices must be configured with
the same SSID.
See netmask.
3